Genie Help, Troubleshooting, and Instructions

Also see: 1 Btn Remotes Help , 2 Btn Remotes Help , 3 Btn Remotes Help , 4 Btn Remotes Help , Accessories Help , Capacitors Help , Circuit Boards Help , Garage Door Openers Help , Gate & Door Operators Help , Keypads Help , Mini remotes Help , Receivers Help and Replacement Parts Help

Need help reprogramming your genie intellicode garage door opener remotes?

1. I purchased an additional Remote Control:
If you have simply purchased an additional remote control and wish to program it and not delete any other device:
press and release the learn code button on the receiver.
While the red LED is blinking, press your transmitter button 3 times.
This will lock in a new code and you will be able to use your remote control normally.
Repeat this process for each additional remote you have.
2. My Remote Control was lost, stolen, or needs to be reset:
If your remote control has been lost or stolen, a person will have unabated access to your garage. You should erase all existing remote controls out of your receiver.
STEP 1: To erase all controls:
Press and hold the learn code button until the red LED stops blinking. This process will take approximately 10 seconds. This will render all remote controls and your optional external wireless keypad inoperative.
STEP 2: To reprogram your new and/or existing remote controls:
Press and release the learn code button on the receiver, while the red LED is blinking, press your transmitter button 3 times. This will lock in a new code and you will be able to use your remote controls normally. Repeat this process for each additional remote control you have.
To re-program your existing Intellicode Wireless Keypad. Press and release the learn code button on the receiver, while the red LED is blinking, open the cover on your wireless keypad, press the same personal pin number that you originally programmed and press the SEND button 3 times. This will allow you to use your keypad normally.