QSeal 290 Black loop sealant
- Q-Seal 290S is used as a protective seal for traffic detector wire loops employed in actuated intersections. It may be used as a sealant for saw cuts in concrete or asphalt surfaces.
- Chemque Q290S loop sealant is available in both black and gray. The sealant provides a water-tight seal when installing loops and works great with both asphalt and concrete applications providing a weather and chemical resistant waterproof seal.
- Chemque's high quality loop sealant is available by the cartridge at a reasonable price and includes a 3/16" sealant tip for easy application. With the modified sealant tip, applying loop sealant has never been easier. Fill the groove in ONE pass from the bottom up! No more waiting around to apply a second coat of sealant.
COVERAGE PER CASE - (12 TUBES):
|1/4" Wide Saw Cut
|3/8" Wide Saw Cut
Q-Seal 290S will skin over in approximately 3 hours at 77°F and 50% R.H. At temperatures below 77°F this product will take proportionately longer time to cure. At temperatures above 77°F it will take a proportionately shorter time to cure.
Remove standing water. The substrate should be dust free and as smooth as possible before installation of Q-Seal 290S. It is recommended that surface temperatures at time of sealant application should not exceed 100°F nor fall below 35°F.
Use Chemque solvent S-231 or S-235. Caution: Clean equipment after use. Use Chemque Q-CLEAN to remove sealant from your hands.
Q-Seal 290S detector Loop Sealant exhibits exceptional chemical resistance to the following chemicals:
- De-icing salts
- Hydraulic Brake Fluid
- Motor Oil
- Sodium Chloride (5%)
SAFETY & HANDLING:
Contains MDI(methylene diisocyanate). Keep away from heat and open flames. Use only in well ventilated areas. Do not breath vapours. In case of contact, immediately flush eyes or skin with plenty of water for at lest ten minutes. If contact is made with eyes, get immediate medical attention.
Find Similar Products by Category
Customers also viewed